10
6. With the help of a second person, hold the con-
sole assembly (E) near the Uprights (96).
Connect the Upright Wire (92) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Then, connect the pulse wires (F). Make sure to
connect the pulse wires on the right side (not
shown) also.
E
96
6
F
92
92
Console
Wire
To Next Page
Loading...
