11
8. Identify the Left and Right Trays (107, 109).
Press the Left and Right Trays (107, 109) into
the console assembly (E).
107
8
E
109
1
E
G
7
6
4
C
D
E
C
7. With the help of a second person, hold the
console assembly (E) near the left handrail
assembly (C). Position the wires (G) so that
they will not get pinched as you set the console
assembly on the left handrail assembly. Be care-
ful not to pinch any wires.
See the inset drawing. Make sure that the con-
sole assembly (E) is flush against the handrail
assemblies (C, D) in the locations shown by the
arrows.
Attach the console assembly (E) to the handrail
assemblies (C, D) with four 5/16" x 3/4" Screws
(1), four 5/16" Flat Washers (6), and four 3/8"
External Star Washers (4) as shown (only one
side is shown). Start all four Screws and then
tighten them.
To Next Page
Loading...
