INSTALLER: PLEASE LEAVE THESE INSTALLATION INSTRUCTIONS WITH THE HOMEOWNER.
Specifi cations & illustrations subject to change
without notice or incurring obligations.
O’ Fallon, MO | Printed in U.S.A. (06/10)
INSTALLATION / PERFORMANCE CHECK LIST
REFRIGERATION SYSTEM:
Was unit given 24 hr warm up
period for crankcase heaters
(if applicable)?
YES NO
Stage-1 Liquid Pressure (high side) ___________
Stage-1 Suction Pressure (low side) ___________
Has the owner’s information
been reviewed with the
customer?
YES NO
Has the Literature Package
been left with the unit?
YES NO
INSTALLATION ADDRESS:
CITY _______________ STATE ____________
UNIT MODEL # ___________________________
UNIT SERIAL # ___________________________
Unit Installed Minimum
clearances per Figure 2
(page 5)?
YES NO
INSTALLER NAME:
CITY ________________
STATE ___________
ATTENTION INSTALLERS:
It is your responsibility to know this product better
than your customer. This includes being able to install
the product according to strict safety guidelines and
instructing the customer on how to operate and
maintain the equipment for the life of the product.
Safety should always be the deciding factor when
installing this product and using common sense plays
an important role as well. Pay attention to all safety
warnings and any other special notes highlighted in
the manual. Improper installation of the furnace or
failure to follow safety warnings could result in serious
injury, death, or property damage.
These instructions are primarily intended to assist
qualifi ed individuals experienced in the proper
installation of this appliance. Some local codes
require licensed installation/service personnel for
this type of equipment. Please read all instructions
carefully before starting the installation. Return
these instructions to the customer’s package for
future reference.
PROPOSITION 65 WARNING: This product
contains chemicals known to the state of
California to cause cancer, birth defects or other
reproductive harm.
WARNING:
ELECTRICAL SYSTEM:
Electrical connections
tight?
YES NO
Line voltage polarity
correct?
YES NO
Rated Voltage: ______________________ VOLTS
L1-L2 Volts: ________________________ VOLTS
Avg. Volts: _________________________ VOLTS
Max. deviation of voltage
from avg. volts: ______________________ VOLTS
% Volt imbalance: ___________________ VOLTS
Blower Motor HP: ______ Sheave Setting ________ # Turns
Has the thermostat been
calibrated?
YES NO
Is the thermostat level? YES NO
Is the heat anticipator
setting correct?
(If Applicable)
YES NO
7092010 (Replaces 709067A)
¢709201l¤
To Previous Page
Loading...
Need help?
General
