Operation
Loading the Paper Roll and Ink Ribbon
44
Operation
Loading the Paper Roll
and Ink Ribbon
This section describes how to load the paper roll and ink
ribbon in the preparation to start printing, after
connecting the printer as described on page 42.
Notes
• Each printing pack contains two sets of the ink ribbon
and paper roll combination. Use the ink ribbon and the
paper roll in the carton as a set. Do not mix with other
varieties of ribbon or paper roll. (See “Ink Ribbon and
Paper” on page 65.)
• One set of the ink ribbon and paper roll allows you to
print the following number of sheets.
For detailed information on the printing pack, see “Ink
Ribbon and Paper” on page 65 and “Self-Laminating
Color Printing Pack” on page 66 in the
“Specifications.”
• Do not replace the printing pack if it has only been
partially used. The number of printouts that can be
printed may not be guaranteed if you replace the ink
ribbon and paper before they have run out.
• Do not detach the black and white spools of the ink
ribbon until you start loading the ink ribbon.
• A built-in IC chip is located around one side of the
black spool. Be careful not to remove the IC seal,
hurt it, or give it a shock. If you do, you may not be
able to use the ink ribbon any more.
• Be sure not to open the wrapping with a knife such as
a cutter. This may damage a paper roll and ink ribbon
and you may not be able to use them for printing.
• Since, like other color dyes, the dyes used in this ink
ribbon may discolor over time, the product will neither
be replaced nor be warranted against any color
change.
Cautions on handing the paper roll
• Place the paper roll vertically. If you place the paper
roll horizontally, the paper may roll around and fall.
This may cause an injury.
• Hold the paper roll with both hands so that you do not
drop it, because it is heavy. Dropping may result in an
injury.
Print
pack
2YNR-
R153
2YNR-
R154
2YNR-
R155
2YNR-
R156
Printing
capacity
610 (sheets) 550 (sheets) 335 (sheets) 295
(sheets)
Print
size
89
×127 mm 102×152
mm
127×178
mm
152×204
mm
3.5
×5
inches
4×6 inches 5×7 inches 6×8
inches
White spool
Black spool
IC seal into which the IC
chip is built
Hold the paper roll with both hands.
To Next Page
Loading...
