Operation
Menu Operations
59
To display the total number of printings
made so far since you started to use the
printer:
Select “TOTAL PRINTS.”
3
Press the MENU button after confirming.
The printer returns to the on-line mode.
Displaying the Firmware Version of
the Printer
The version of the firmware of the printer can be
displayed.
1
Press the MENU button.
The printer is switched to off-line.
2
Press the F and f buttons to display VERSION.
3
Press the MENU button after confirming.
The printer returns to the on-line mode.
Adjusting the Position of the
Printout Image
You can adjust the position of the printout image as
shown in the illustration in step 3, below, for the 2YNR-
R153 and the 2YNR-R155. Adjust the image position,
as required, or when the blank portion appears on the
edge of the printout.
1
Press the MENU button.
The printer is switched to the off-line mode.
2
Press the F and f buttons to display PRINT
OFFSET.
3
Press the G and g buttons to shift the printout image
to the desired position, while looking at the
printout.
L1: Moves to the left by 0.6 mm from the default
position.
L2: Moves to the left by 1.2 mm from the default
position.
R1: Moves to the right by 0.6 mm from the default
position.
Press F and f to display TOTAL PRINTS.
Total number of printings since turning on the printer
1,3
2
Press F and f to display VERSION.
Version of the firmware of the printer
1,423
Press F and f until PRINT OFFSET appears.
The offset amount for the current position
To Next Page
Loading...