Operation
Loading the Paper Roll and Ink Ribbon
50
8
Pull the ribbon base down.
9
Hold both spools and push the black spool into the
black spool holders.
Since the thermal head is still very hot just after
printing is finished, be careful not to touch the
thermal head when loading the ink ribbon.
10
Detach the white spool from the black spool. Pull it
upward while winding it off so that the ribbon will
not loosen. And then push it into the white spool
holders.
Note
When attaching the white spool, check that the ink
ribbon does not loosen or is not wrinkled. If the ink
ribbon is wrinkled, smooth it.
11
Close the front door by pushing it in the center part
of the front door.
Note
• Close the front door after confirming that the
ribbon base is pulled down.
• If you close the front door by pushing it on one
side, the front door may not be completely
locked.
The printer feeds a certain amount of paper and is
then ready to print.
Notes on storage
• Avoid placing the printer where it will be subject to:
high temperatures,
Caution
Insert the left side of the black spool first,
then the right side and push it until it clicks.
Insert the left side of the white spool first,
then the right side and push it until it clicks.
To Next Page
Loading...
