Nortek GHH09(2.6)LUK4DH - Post-Installation Checklist

29
4.Replace wiring cover and tighten the screw.
5.Close the panel.
Installation of indoor unit
Note:
Ɣ
Ɣ
All wires of indoor unit and outdoor unit should be connected by a professional.
Only single unbroken electrical wires should be used. Spliced wires are not allowed.
installation.
Ɣ)RUWKHDLUFRQGLWLRQHUZLWKRXWSOXJDFLUFXLWEUHDNHUPXVWEHLQVWDOOHGLQWKHOLQH
The circuit breaker should be all-pole parting and the contact parting distance
VKRXOGEHPRUHWKDQPPLQ
5HPRYHWKHZLUHFOLSFRQQHFWWKHSRZHUFRQQHFWLRQZLUHWRWKHZLULQJWHUPLQDO
with wire clip.
power connection
wire
cable-cross
hole
2. Lead the power wire
through the cable-cross hole at the back
RILQGRRUXQLWDQGWKHQSXOOLWRXWIURP
the front side.
2 1
2 1 L L2 G
Outdoor unit connection
、24K:
2 1
2 1 LN
Outdoor unit connection
09、.
09、.IRUVRPHPRGHO
2 1
Outdoor unit connection
L2/
2 1
secure
wire