Nortek GHH09(2.6)LUK4DH - Securing Pipes and Unit

28
4. Wrap the indoor pipe and joint of con-
nection pipe with insulating pipe, and
then wrap it with tape.
Step six: install drain hose
Installation of indoor unit
torque wrench
open-end
wrench
indoor pipe
pipe
union nut
Hex nut diameter Tightening torque (N
.
m)
ĭ（1/4 in）
ĭLQ
ĭ（LQ）
ĭ（LQ）
ĭLQ
a
a
a
a
a
insulating pipe
1. Connect the drain hose to the outlet pipe of
indoor unit.
6HFXUHWKHMRLQWZLWKWDSH
outlet
pipe
drain hose
drain hose
tape
outlet pipe
drain hose
insulating pipe
Note:
Ɣ Add insulating pipe in the indoor
drain hose in order to prevent
condensation.
Ɣ The plastic expansion anchors are
not provided.
1. Open the panel, remove the screw
on the wiring cover and then take
down the cover.
wiring cover
screw
panel
Step seven: connect wire of indoor unit