Nortek RC - 2.4 Basic operation instructions; 2.5 Replacing batteries in remote controller and notes

3DJH
User’s Manual of Remote Controller
3
）
Pressing button, is displayed and air function is turned on.
4
）
Press button until is disappeared, then air function is turned off.
5
）
When the indoor unit is connected with fresh air valve, air function setting can
control the connection of fresh air valve, which can control the fresh air
volume and improve the air quality inside the room.
（
8
）
Setting X-FAN function
In unit on status, press X-FAN button to turn on or turn off X-FAN function.
1
）
When is displayed, X-FAN function is on.
2
）
When is not displayed, X-FAN function is off.
3
）
When X-FAN function is on, the water on the evaporator will be blown away
after turning off the unit to avoid mildew.
（
9
）
Setting timer
You can set the operation time of unit as you need. You can also set timer on and
timer off in combination.
Before setting, check if the time of the system is the same as the current time. If not,
please set the time according to current time.
1
）
Setting timer off
a. Pressing TIMER OFF button, OFF is blinking and time displaying zone
displays the timer time of last setting.
b. Press ▲ or ▼ button to adjust the timer time.
c. Press TIMER OFF button again to confirm setting. OFF is displayed and time
displaying zone resumes to display current time.
d. Press TIMER OFF button again to cancel timer and OFF is not displayed.
2
）
Setting timer on
a. Pressing TIMER ON button, ON is blinking and time displaying zone displays
the timer time of last setting.
b. Press ▲ or ▼ button to adjust the timer time.
c. Press TIMER ON button again to confirm setting. ON is displayed and time
displaying zone resumes to display current time.
d. Press TIMER ON button again to cancel timer and ON is not displayed.
（
10
）
Setting energy-saving function
1
）
If you want to turn on energy-saving function:
2
）
When the unit is o
p
eratin
g
, will be blinkin
g
if SAVE button is
p
ressed.