²¡Ý
Cancel
²£¡Ý
Send calls arriving on an external line to another telephone outside your
system. (Some external lines may not support this feature. See your system
coordinator.) This feature is not available on the T7100/M7100 telephone.
²àÚ
Generate a Link signal
‹
to access a PBX or other host exchange.
²¡â¡
Generate a tone for as long as you hold down a button. This is used to
communicate with devices like fax or answering machines. Long tones are in
effect only for your current call.
²Ú
Cancel
²£Ú
Send a message to another telephone within your system.
To view and reply to your messages:
1. Press
²ßÞ
.
2. Press
¥
and
£
to view your message list.
3. Press
â
to call the person who left you the message.
To erase a message:
1. Press
³
while viewing a message.
²¥¡Ú
Change the position of your line or hunt group buttons.
1. Press
²¥¡Ú
.
2. Press the line button that you want to move.
3. Press the button that you want to move the line to.
4. Press
¨
. The two buttons are exchanged.
5. Update the button label strip on your telephone.
Line buttons cannot be exchanged with intercom, answer or Handsfree
buttons.
²¡Úá
Block the outgoing name and/or number on a per-call basis.
1. Press
²¡Úá
.
²ßâ
and code (1 to 3) and zone (0 to 6)
Make a page announcement through either the internal (code 1) or external
(code 2) speakers, or both (code 3). Zone 0 pages all zones.
Page announcements are programmed to timeout after a pre-selected
amount of time which is set by your system coordinator.
Internal page
²ßÚ
and zone (0 to 6)
Make a page announcement to all, or to a specific group of telephones,
through the telephone speakers. Zone 0 pages all zones.
Line
Redirection
Link
Long Tones
Messages
Moving line
buttons
Name and
number
blocking
Page
To Next Page
Loading...
Need help?
General
