²ßà
Save a number to redial later. Enter the code while you are on a call that you
have dialed to save the number. Enter the code when you are not on a call to
redial the saved number.
Show service schedules
²¡àâ
Display the modes that have been turned on at a designated control set.
Ringing service
²¡àÚ
Cancel
²£¡àÚ
Turn on one of six schedules for alternative ringing/call answering
arrangements from a designated control telephone.
Restriction services
²¡àÛ
Cancel
²£¡àÛ
Turn on one of six services for restrictions on particular lines or telephones
from a designated control telephone. You will be required to enter a
password.
Routing services
²¡àÜ
Cancel
²£¡àÜ
Turn on one of six services for routing on particular lines or telephones from a
designated control telephone. You will be required to enter a password.
²â
Dial an external telephone number using a three-digit code.
There are two types of speed dial codes: system (001 to 255) and user (256
to 279).
System speed dial codes can be used from any display telephone in the
system. They are assigned by your system coordinator.
User speed dial codes are used exclusively at your telephone.
To make a call using a speed dial code:
1. Press
²
â
.
2. Enter the three-digit code for the number.
To program user speed dial numbers:
1. Press
²¥Ý
.
2. Enter a three-digit code from 256 to 279.
3. Specify an external line by pressing a line button, a line pool button, or the
intercom button. If you do not specify the line, the system automatically chooses
a line for the call.
4. Dial the telephone number you want to program (up to 24 digits).
5. Press
³
.
6. Record the code and number you have just programmed.
You cannot program user speed dial numbers while someone else is
programming your system. Codes you enter can be overridden by your
system administrator.
Saved
Number
Redial
Service
Schedules
Speed Dial
To Next Page
Loading...
Need help?
General
