• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
4
67
5
Wall Mount
Connect the receiver and receiver
cord .
Attach the wedge-shaped base in
desk mount or wall mount
†
position.
Connect the line cord
.
Connect the power adaptor .
Attach the language faceplate. Attach the receiver card and lens
(shiny-side down).
Place you Vista 100 Phone on a
table or hang it on a wall. Then fit
the Discovery Card over the keys on
the phone
When you have power:
When you plug in your new phone, you may see a message on the display ask-
ing you to make a language selection. Read the directions on the display to
select one of two languages.
Vista 200 also runs a test to ensure that the phone cords are connected properly. If
the test fails, the display will prompt you to check the phone cords. Make sure
all connections are fastened securely.
3
1
Desk Mount
2
1
† For wall mounting we recommend that you use a wall mounting plate, which your local telephone company
can install. The excess line cord fits into the stand of the phone for wall mounting.
Installing Your Vista 100 Phone
Set Up as easy as 1,2,3
To Next Page
Need help?
General
