14
6 Maintenance and service
ATTENTION : to perform maintenance on the machine, always switch it off. Always wear a face
mask and safety goggles while performing the maintenance of machine.
6.1 Maintenance of the machine
To ensure a long-term quality from the cutting with the CS1, please follow the maintenance plan
below:
Regular service period
Perform at every indicated period
After one hour of work
Begin of the day
During the changing of the tool
End of the day
Every week
After a fault
After a damage
Visual control (general aspect,
watertightness)
Whole machine
Clean
Flange and blade fixing devices Clean
Belts tension Control
Water hoses and nozzles Clean
Depth screw Grease
Engine housing Clean
Reachable nuts and screws Tighten up
Adjustment and replacement of the belts
After one hour of work, the belts heat and stretch. Therefore, you have to re-tension them.
To adjust the belts, firstly remove the belt guard by unscrewing the 2 nuts. Loose the 2 bolts at
the back of the engine-plate and shift the engine by using the screw on the back of the plate to
retighten the belts.
To replace the belts, move the engine completely down by unscrewing the screw at the back of
the engine-plate. Adjust the belts and retighten them using the screw at the back of the engine
plate.
Always use a matched set of belts. Do not replace single belts. After controlling or retightening
the belts, reassemble the belt guard on the frame of the machine.
Lubrication
The CS1 uses life-lubricated bearings. Therefore, you don’t need to lubricate them at all.
Grease the depth screw every day.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work.
To Next Page
Loading...
