16
Air cleaner
The CS1 has a dual type filter.
To service the air cleaner filter, follow
these instructions:
• Remove the nut, air cleaner cover and
wing nut.
• Remove the pre air cleaner elements
and separate them.
• Carefully check both elements for
holes or tears and replace if damaged.
• Paper element: tap element lightly
several times on a hard surface to
remove excess dirt or blow
compressed air lightly through the filter
from the inside out. Never brush the
dirt off; brushing will force dirt into the
fibres.
• Foam element: clean in warm soapy
water, rinse and allow to dry
thoroughly. Dip the element in clean
engine oil and squeeze out all the
excess. The engine will smoke during
initial start-up if too much oil is left in
the foam.
• Shine a light through the elements,
and inspect them carefully. Reinstall
the elements if they are free of holes
and tears.
Fuel strainer cup
To service fuel strainer cup, follow these
instructions:
• Turn off the fuel valve and remove the
strainer cup.
• Clean the strainer cup with solvent.
• Install the O-ring and strainer cup.
• Tighten the strainer cup to 4N.m.
To Next Page
Loading...
