Norton clipper TR 200 E - Operating the Machine; Site of Work; Cutting Methods; Cutting with an Angle

13
5 Operating the machine
5.1 Site of work
5.1.1 Siting the machine
 Remove from the site anything, which might hinder the working procedure!
 Make sure the site is sufficiently well lit!
 Observe manufacturer's conditions for connecting to power supplies!
 Place electric cables in such a way that damage by the device is excluded!
 Make sure you have a continual adequate view of the working area so you can intervene in the
working process at any time!
 Keep other staff out of the area, so you can work securely.
5.1.2 Space required for operation and maintenance
Leave 2 m in front of the machine and 1,5 m around it for usage and maintenance of the TR200E.
5.2 Cutting methods
To use the machine correctly, you must face it with one hand on the cutting head, and one on the
tile to be cut to maintain it against the material stops. Always keep your hands away from the
moving blade.
5.3 Cutting with an angle
You can cut from 0º to 45º by tilting the head. To this purpose:
 Loosen the two knobs maintaining the head to tilt the head to the desire angle.
 Retighten the two knobs.
5.4 General advice for the cutting
 Only tiles with max. dimensions 580x400x15mm and max. weight 3kg can be cut with the
machine.
 Before commencing work make sure tools are firmly seated!
 Select the right tools as recommended by the manufacturer depending on the material to be
worked, the working procedure (dry or wet cut) to be carried out and the required efficiency.
 Make sure the water pan contains enough water.
 Set the guide-a-cut to the desired width of cut, and to the desired angle using the two engraved
measurements to align it correctly.
 Do not force on the motor. This machine is not designed for a continuous use.