15
7 Faults: causes and cures
7.1 Fault-finding procedures
Should any fault occur during the use of the machine, turn it off, and isolate it from the electrical
supply. Any works dealing with the electrical system or supply of the machine can only be carried
out by a qualified electrician.
7.2 Trouble-shooting guide
Check the electrical supply
(fuse for example)
Connection cable section too
small
Defective connection cable
CAUTION : can only be solved
by qualified electrician
Change motor or contact motor
manufacturer
Not enough water in the pan
Water supply system is blocked
up
Clean water supply system
Water pump is not working
To Next Page
Loading...