Operation Description
28
2.14.5 Use of multiway valve（Optional）
• Switch off the engine.
• Put the lifter in lowering position.
• Move the hydraulic output valve operation handle
forward and backward, in order to eliminate the
pressure in the hydraulic adapter seat.
• Take out the sealing cover of the adapter seat and
clean the adapter.
• Connect the spare male connector to the female
connector with the quick change coupler, and then
connect the oil inlet and outlet of the
double-action oil tank on the farm machine. The
multi-way valve has four quick change couplers,
with female connections (AB1 and AB2). The
control handle (C) controls the first hydraulic
output (AB1) and control handle D controls the
second hydraulic output (AB2).
Figure 2-26 Multi-Way Valve (25XT)
IMPORTANT NOTES:
1 When a hydraulic output device is used, the connector seat should be covered with a seal cover to
avoid dust.
2 After the hydraulic output device is used, the operating handle should be set to the neutral position,
otherwise, the hydraulic system may overheat.
To Next Page
Loading...
