Technical Specifications for XT Series Tractors
66
Type
Unit
20XT 22XT 25XT
Clamping
reverse
gear
0.58,2.69
Type —— KM385T KM385T
Type —— Vertical, water cool, 4 strokes diesel
Number of cylinders ——
2/3
Cylinder diameter x stroke mm 95×105/80×90 100×105/85×90
Combustion chamber mode
straight-injection or swirl
Nominal power kW 14.7 16.2 18.4
Nominal rotate speed r/min 2350 2350 2350
Nominal fuel consumption rate on the
operating condition
≤266.6/≤278.8 or ≤268(KM385BT)
Engine
Nominal oil consumption rate on the
operating condition
g/kW
h
≤2.04/≤2.72
Frame assembly
—— Frame/semi-frame
Front shaft
—— Invert U tube
Front wheel
200~250
Transport
Rear wheel
120~150
Front wheel
200~250
Tire
pressure
Plough
Rear wheel
kPa
100~120
Front wheel —— 4.00-16,or 5.00-16
Tire specification
Rear wheel —— 8.3-24(paddy field tires),or 9.5-24(conventional)
Front wheel toe-in
mm 4~10
Steering gear
—— Worm-roller or hydraulic steering gears
Max. rotating angle, front wheels
50°
Brake
—— Shoe brake
Auxiliary
turning
brake
system
Trailer brake
—— Pneumatic brake
Deep plough control mode
—— Position and floating control
Hydraulic oil pump
——
CBJ30-E06-W5B, or pump CBJ30-E14-W5B /
pump CBJ30-E14L
Oil cylinder diameter x stroke mm 63×100
Opening pressure of the system safety
valve
Mpa 17.5-18
Max. lifting power (610mm behind
rear suspension point)
kN 3.3 3.3 3.3
Working
device
Suspension system mm Rear-mounted, three-point Spherical Hinge, Cat. I
Pin hole diameter of upper suspension
point
mm Φ19
Pin hole diameter of bottom suspension
point
mm Φ22
Simple hydraulic
power take-off
—— Rapid exchange joint 1pc
Hydraulic power
take-off
Multiple direction
valve hydraulic
power take-off
—— Rapid exchange joint 2pcs
PTO shaft(r/min)
Non-independent,540/720(540/1000 optional)
PTO shaft diameter
mm ö35,6 teethed rectangle spline shaft
PTO shaft position
mm Ground clearance 468,or 494
PTO shaft revolving direction
—— Clockwise(viewed from the tractor tail)
Working
device
Height of towing pothook
mm Ground clearance 468,or 494