Nortrac XT20 - Page 83

77
Part Specification Installation Position Quantity
Both ends of rocking shaft 2
JB/T2600
reinforced seal
PD42×62×10 Lift shaft 2
10×13.5 Bleeder plug 1
10×13.5 Cylinder head 2
18×22 Hydraulic output hollow bolt 1
JB/T 982
Sealing gasket
36×42
Oiling ventilation plug
assembly
1
71×2.65G
Sealing part of cylinder
sleeve and housing
1
17×2.65G
Cylinder head regulating
vavle
1
53×5.3G Piston and oil cylinder tube 1
Raiser
GB/T3452.1
O-rings
53×5.3G Piston and oil cylinder tube 1
Handle shaft, safety valve
seat
1
9×2.65G
Composition face between
distributor and lifter housing
1
13.2×2.65G
Safety valve holddown
screwed-in plug
1
15×2.65G
Composition face between
distributor and lifter housing
1
Distributor
GB/T3452.1
O-rings
19×2.65G
Composition face between
distributor and lifter housing
1
Oil pump
and oil
circuit
GB/T3452.1 O-rings 18×2.65G Oil pickup 1
JB/T2600
oil seal
SG30×45×8 Transfer-case output shaft 1
12.5×1.8G Transfer-case shift shaft 1
36.5×2.65G
Front end of rear-jacket
welding case
2
Transfer
case
GB/T3452.1
O-rings
53×2.65G
Back end of rear-jacket
welding member
1
PG45×65×10 Oil seal housing washer 2
SD45×70×10 Front drive shaft 2
SD50×70×12
Lower end of vertical shaft
sleeve
2
JB/T2600
Skeleton oil seal
W50×72×7
Lower end of vertical shaft
sleeve
2
33.5×3.55G Driving bevel gear shaft 2
34.5×3.55G Bearing cap 2
40×3.55G Front pendulum shaft 2
56×2.65G Dust-proof pipe saddle 1
Front
drive axle
GB/T 3452.1
O-rings
67×3.55G Front pendulum shaft 2