NOTTINGHAM ANALOGUE STUDIO
128 CORDY LANE, UNDERWOOD, NOTTINGHAM NG16 5FD
Design and Manufacture of Quality Audio Equipment
Telephone: +(44) (0) 1773 762947
Fax:
+(44) (0) 1773 533566
V.A.T. REGISTRATION NO. 667 3729 92
ASSEMBLY INSTRUCTIONS FOR ‘HEAVY DUTY KITS’
Remove the arm from the turntable.
Position the turntable satellite over the edge of a table. With the standard Allen key, undo the two
headscrews under the armbase. Place the 25mm spacer in and re-connect the armbase to the
satellite using the longer bolts provided.
Position the centre adapter in the middle of the turntable and gently lower the graphite platter
onto the original platter. The damping ring is then placed in the groove between the original and
the new graphite platters.
Replace and set up the arm.
Happy listening.
PLEASE NOTE: Due to the nature of the platter material, you may often find small
imperfections in the top or bottom of the platter. This will make no difference to the function or
the sound.
To Next Page
Loading...
