NOTTINGHAM ANALOGUE STUDIO
128 CORDY LANE, UNDERWOOD, NOTTINGHAM NG16 5FD
Design and Manufacture of Quality Audio Equipment
Telephone: +(44) (0) 1773 762947
Fax: +(44) (0) 1773 533566
V.A.T. REGISTRATION NO. 667 3729 92
Pulley Installation
An adjustment has been made to the packing of Nottingham’s turntables to ensure that
the motor/pulley assembly can better withstand the rigors of shipping in the United
States. Follow these steps to properly affix the pulley to the motor:
1. Locate the pulley (fig. 1)
2. Locate the motor (fig. 2)
3. Slide the hole in the bottom of the pulley (fig. 3) over the post at the center of the
motor, and press down until the pulley stops.
When the turntable is spinning, if you notice rubbing at the bottom of the pulley, simply
pull up on the pulley to eliminate any contact with the motor housing.
Figure 1
Figure 2
Figure 3
Completed motor assembly
To Next Page
Loading...
