Novation Launchpad Pro MK3 User Manual

11
Flashing colour
When sending Flashing colour, the colour flashes between that set as Static or Pulsing colour (A), and
that contained in the MIDI event setting flashing (B), at 50% duty cycle, synchronized to the MIDI beat
clock (or 120bpm or the last clock if no clock is provided). One period is one beat long.
Pulsing colour
The colour pulses between dark and full intensity synchronized to the MIDI beat clock (or 120bpm or
the last clock if no clock is provided). One period is two beats long, using the following waveform:
Examples
For these examples, switch the Launchpad into Programmer Mode.
1. Lighting the lower left pad static red:
Host => Launchpad Pro [MK3]:
Hex: 90h 0Bh 05h
Dec: 144 11 5
This is Note On, Channel 1, Note number 0Bh (11), with Velocity 05h (5). The Channel specifies the
lighting mode (static), the Note number the pad to light (which is the lower left one in Programmer Mode),
the Velocity the colour (which is Red, see Colour Palette).
2. Flashing the upper left pad green:
Host => Launchpad Pro [MK3]:
Hex: 91h 51h 13h
Dec: 145 81 19

Novation Launchpad Pro MK3 Specifications

General

Velocity and Pressure Sensitive	Yes
USB	USB-C
Type	MIDI Controller
Aftertouch	Yes
OS Requirements - PC	Windows 10 or later
Grid	8x8 RGB LED backlit pads
MIDI I/O	MIDI In/Out/Thru
Power Supply	USB bus powered
Pads	64 RGB LED backlit pads
Software	Ableton Live Lite
OS Requirements - Mac	macOS 10.13 or later
Height	1.3 inches (33 mm)
Width	12.6 inches (320 mm)
Depth	12.6 inches (320 mm)
Connectivity	USB-C, MIDI In/Out/Thru
Software Compatibility	Ableton Live, Logic Pro, FL Studio
Included Accessories	USB-C cable, Ableton Live Lite license