Novation Launchpad Pro MK3 User Manual

19
When selecting Live mode with this message, Launchpad Pro [MK3] switches to Session layout, or Note
mode when not in DAW mode.
When selecting Programmer mode using this SysEx message, you may not access the Settings menu.
(usually accessed by pressing the SETUP button). To return the Launchpad Pro [MK3] to normal
operation, use this SysEx message to select any other layout than Programmer mode.
Alternatively, Programmer Mode may be selected manually from the device. Press and hold SETUP to
enter the settings menu, then press the bottom Scene Launch button (lit orange). Now release the SETUP
button to enter Programmer Mode. Note that Launchpad Pro [MK3] will always boot into Live Mode.
Programmer mode layout
Note that in Programmer mode, all buttons and pads accept either Note or Control Change messages.
The indicated type is which is sent by the device on the MIDI interface when the corresponding button
or pad is pressed.

Novation Launchpad Pro MK3 Specifications

General

Velocity and Pressure Sensitive	Yes
USB	USB-C
Type	MIDI Controller
Aftertouch	Yes
OS Requirements - PC	Windows 10 or later
Grid	8x8 RGB LED backlit pads
MIDI I/O	MIDI In/Out/Thru
Power Supply	USB bus powered
Pads	64 RGB LED backlit pads
Software	Ableton Live Lite
OS Requirements - Mac	macOS 10.13 or later
Height	1.3 inches (33 mm)
Width	12.6 inches (320 mm)
Depth	12.6 inches (320 mm)
Connectivity	USB-C, MIDI In/Out/Thru
Software Compatibility	Ableton Live, Logic Pro, FL Studio
Included Accessories	USB-C cable, Ableton Live Lite license