There are a maximum of 2 parameters displayed on any page. One for each line on the display. The upper & lower Data knobs on
the right of the display are used to alter these parameter’s values.
Page 1 looks like so:
The higher parameter is “Master tune”. In this case with a value of +00.
This parameter determines Global tuning of Supernova II Rack. Use the upper Data knob to adjust this parameter. The range of
this parameter is -64 to +63 cents. This parameter is memorised as Global.
To write any changes to this parameter into memory press the “Write” button while in this mode. Also note the “Memory Protect”
has to be set to “Off” for this to be possible.
The lower parameter is “Global MIDI chan”. In this case with a value of 1.
This parameter determines the Global MIDI Channel for the Supernova II Rack. This Channel is used when in Program Mode & for
transmission & reception of Sysex data. Use the lower Data knob to adjust this parameter. The range of this parameter is 1 to 16.
This parameter is memorised as Global.
To write any changes to this parameter into memory press the “Write” button while in this mode. Also note the “Memory Protect”
has to be set to “Off” for this to be possible.
Page 2 looks like so:
The higher parameter is “Sysex transmission”. In this case with a value of Single Program.
This parameter selects the type of data to be dumped via MIDI. Use the lower Data knob to adjust this parameter. Whatever value
is set on the lower line of the display is transmitted when the MIDI button is pressed in the Part edit section. The range of this para-
meter is Single program, All programs, Single prog request, All progs request, Single performance, All performances, Single perf
request, All perfs request, Single arp pattern, All arp patterns, Single patt request, all patts request, Global parameters, Globals
request, Program bank A, Program bank B, Program bank C, Program bank D, Program bank E, Program bank F, Program bank
G, Program bank H, Program bank A request, Program bank B request, Program bank.C request, Program bank D request,
Program bank E request,Program bank F request,Program bank G request,Program bank H, Performance bank A, Performance
bank B, Performance bank C & Performance bank D, Performance bank A request, Performance bank B request, Performance
bank C request, Performance bank D request, Drum map a, Drum map b, Drum map c, Drum map d, Drum map e, Drum map f,
Drum map g, Drum map h, Drum map a request, Drum map b request, Drum map c request, Drum map d request, Drum map e
request, Drum map f request, Drum map g request, Drum map h request, Total data & Total data request. This parameter is memo-
rised as Global.
The Supernova II Rack can accept System Exclusive dumps while in any mode.
To write any changes to this parameter into memory press the “Write” button while in this mode. Also note the “Memory Protect”
has to be set to “Off” for this to be possible.
To Next Page
Loading...
