MODE SECTION
Page 3 looks like so:
The higher parameter is “Sysex Reception”. In this case with a value of Normal (Rx as sent).
This parameter determines if incoming Sysex data will be received & if it is a bank dump, which bank it will be written in. Use the
lower Data knob to adjust this parameter. If this parameter is set to “Normal (Rx as sent) the system exclusive is enabled & any
incoming bank dumps will be stored in the same location as they were sent. i.e. a Prog bank A dump will be written to Prog bank A.
If this parameter is set to “All progs to bank A”, any incoming Program bank dump will be written into Program bank A regardless of
its original location when transmitted. If this parameter is set to “All perfs to bank A”, any incoming Performance bank dump will be
written into Performance bank A regardless of its original location. If this parameter is set to “Disabled” no sysex messages will be
recognised. The range of this parameter is Disabled, Normal (Rx as sent), All progs to bank A, All progs to bank B, All progs to
bank C, All progs to bank D, All progs to bank E, All progs to bank F, All progs to bank G, All progs to bank H, All progs to Dmap a,
All progs to Dmap b, All progs to Dmap c, All progs to Dmap d, All progs to Dmap e, All progs to Dmap f, All progs to Dmap g, All
progs to Dmap h, All perfs to bank A, All perfs to bank B, All perfs to bank C & All perfs to bank D. This parameter is memorised as
Global.
To write any changes to this parameter into memory press the “Write” button while in this mode. Also note the “Memory Protect”
has to be set to “Off” for this to be possible.
Page 4 looks like so:
The higher parameter is “MIDI clock”. In this case with a value of Int.
This parameter determines If the Supernova II Rack is syncing to Internal or External MIDI Clock. Use the upper Data knob to
adjust this parameter. The range of this parameter is On & Off. This parameter is memorised as Global.
To write any changes to this parameter into memory press the “Write” button while in this mode. Also note the “Memory Protect”
has to be set to “Off” for this to be possible.
The lower parameter is “Pedal/breath control”. In this case with a value of Off.
This parameter determines if the Supernova II Rack re-maps incoming Pedal data & Breath Control MIDI data ( CC no 2 ) into Mod
wheel data ( CC no 1 ), Aftertouch data or any controller from 3 to 119 & Pitchbend data . Use the lower Data knob to adjust this
parameter. This allows incoming Pedal & Breath Control data to manipulate most of Supernova II Racks key parameters directly.
The range of this parameter is Off, MW, A/T, CC3 to 119, Bend, Bend+, Bend-, NRPN75 to NRPN77, NRPN95 and NRPN96. This
parameter is memorised as Global.
To write any changes to this parameter into memory press the “Write” button while in this mode. Also note the “Memory Protect”
has to be set to “Off” for this to be possible.
To Next Page
Loading...
