Master Section
Master section
Although unlabelled as such, this section houses certain ‘master’ controls that affect the
V-Station
PROGRAM up/down buttons
Use these to select programs in the V-Station. You can click on them individually to go through
the sounds one-by-one but if you click and hold these buttons, the program selection will
increment / decrement in units of 10 to make program selection quicker and easier.
VOLUME Knob
This control adjusts the overall output volume on the main master audio outputs. This control
can be useful for preventing distortion on your sequencer’s mixer.
LCD
This ‘virtual’ LCD allows you to see program numbers and names. However, when you move
the cursor over any knobs and switches, after a short delay, the parameter name and its value is
shown on the LCD:
COMPARE button
Clicking and holding this button when editing a sound allows you to compare the original with
your edited version.
WRITE button
Allows you to write any sounds you edit or create to the V-Station’s memory. Clicking on this will
put a prompt in the LCD:
If you want to over-write the existing sound, simply click on CONFIRM - the sound will be written
to the current location.
Note : The destination memory is always initially set to the currently selected program’s
number.
35 MAIN panel / Operation
To Next Page
Loading...