Mod Wheel
AMP
AMP GAIN By routing the Modulation wheel to the amplifier, the overall volume of the
sound may be controlled. Positive values of 1 to 63 increase the output
volume of the Amp Envelope as the Modulation Wheel is pushed forwards.
Negative values from -1 to -64 decrease the output volume of the Amp
Envelope as the Modulation Wheel is pushed forwards. At a setting of 0, the
wheel will have no effect.
Pitch bend
These three controls allow you to set the pitch bend range for each oscillator individually. The
value shown when the controls are adjusted shows the number of semitones the pitch bend
wheel will affect the oscillators’ pitch.
Under normal circumstances, each oscillator should be set to the same value. However, by
having independent control of each oscillator individually, you have an enormous amount of
flexibility to set different pitch bend ranges for special performance effects. In fact, one
application where this is useful is in the case of using Oscillator Sync. By setting pitch bend on
Oscillator 1 to zero and a wide pitch bend range to Oscillator 2, you can use the pitch bend
wheel to create the tearing sync sweep effect.
69 CONTROLS panel / Operation
To Next Page
Loading...