Panning
Panning
The Panning function in the V-Station performs the same function as the PAN knob on a
mixing console. It can be used to position a sound anywhere from left to right in the stereo
field.
POS Knob
Uniquely, the PANNING effect does not have a LEVEL control. Instead, it has a POS (an
abbreviation for ‘position’) control to place the sound in the left / right output.
MOD RATE Knob
Controls the panning LFO’s speed. If the Mod Depth (see below) is set to a non zero value, the
panning LFO will move the sound from the Left to the Right at a speed determined by this Rate
setting
Note : The panning LFO should not be confused with the two LFOs available on the
V-Station’s MAIN panel.
MOD DEP Knob
The panning effect has its own dedicated LFO (not to be confused with the two LFOs available
on the V-Station’s MAIN panel) which can be used to automatically pan a sound backwards and
forwards across the stereo field. This control (an abbreviation of ‘modulation depth’) controls
the depth of this automatic panning effect.
When Mod Depth is set to zero, no automatic panning will be applied and the position of a
sound in the stereo field will be static, being solely determined by the POS(ition) control.
52 MAIN panel / Operation
To Next Page
Loading...