Preferences
NUMPAD PROGRAM SELECT LEDs
This preference allows you to enable program selection using your computer keyboard’s
numeric keypad. With this enabled, programs can be selected by typing in a three digit number
(100 - 400).
Note : Some sequencers use the numeric keypad for play, stop, locating and other functions.
Some sequencers allow you to re-assign these so that you can use the keypad for other
purposes. Others, however, do not. If your sequencer doesn’t allow you to re-assign the
numeric keypad, you won’t be able to select programs numerically from your keypad. You
should switch NUMPAD PROGRAM SELECT off.
79 GLOBAL panel / Operation
To Next Page
Loading...