Chapter1 Introduction
Manual of NVEM
- 3 -
Figure1-2. The other side of NVEMV2.1and installation dimensions
1.4 substantival explanation
When operate the NVEM,where will be a lot of English abbreviation,now we list all of
them for your kindly references:
FRO:Feedingadjust:During the operating process,the F value already set,and need to
adjust the current feeding speed, then we can adjust FRO value to realize it.
SRO: Spindle speed adjust: During the operating process, the S value already set, and need
to adjust the current spindle speed, then we can adjust SRO value to realize it :
To Next Page
Loading...
