Test Result 3: Abnormal pair and length (PAIR &LENGTH) display
It will display the paired lines first if there is unpaired lines in the pair and
length (PAIR & LENGTH) measurement:
P a i r 1 2 1 0 0 . 0 m
7 8
P a i r 3 6 1 0 0 . 3 m
P a i r 4 5 1 0 0 . 2 m
In which, the last line (78 ) icates there is no pair is found in lines 7and 8, at
the moment, it will display the length of unpaired line number(as shown below):
if you push the key: ( Or push PAIR&L key to return the main menu)
It will display " X " to indicate an open circuit if the length is less than 90% of
other line pair length and the open circuit is located at around 89.3M from the
tester. (The open circuit line number could be rechecked by WIREMAP
function.)
At the moment, push key to go back previous picture and push key to show
further unpaired line number length.(Or push key to return the main menu)
P i n 7 1 0 0 . 0 m
P i n 8 8 9 . 3 m x
Coaxial cable and telephone line measurement function:
After entering into coaxial cable and telephone line measurement (Coax/Tel)
function, the tester shall have test and show the test result as follows:
C o a x / t e l t e s t
P a s s
It shall display OPEN if there is any open circuit or the coaxial cable and
telephone line is not connected.It shall display SHORT if there is any short
circuit.At the moment,push key to repeat the measurement or push
key to return the main menu. The far-end recognizer will have beep prompt
sound if the connection is in normal condition.
“ ”
“ ”
Note: For coaxial cable measurement, it needs accessories: two (2) BNC
matchers. One is used to connect M port RJ45 and the cable to be checked
and the another is used to connect the far-end matcher R port and the cable
to be checked.
For telephone line measurement,it needs accessories:two(2)RJ11 matchers.
One is used to connect M port RJ45 and the cable to be checked and the another
is used to connect the far-end matcher R port and the cable to be checked.
-09-
PAIR&L
PAIR&L
To Next Page
Loading...