19
Dual 850/ 1300 nm 850 nm 1300 nm Dual 850/ 1300 nm ...
Press and hold the • key to switch to the CW mode at the currently selected wavelength.
Note: If the OLS1 operates in the Dual WAVE ID mode, it will switch the output port to the next
wavelength in a sequence as follows:
Dual 850/1300 nm WAVE ID key Press and hold 850 nm CW
CW Mode
Press and hold the • key to select wavelengths in the following sequence:
850 nm 1300 nm 850 nm ...
Press the key to return to the WAVE ID mode at the currently selected wavelength. •
Power key4. - Press and hold the key until all indicators light up to turn the OLS1-Dual on or off. The
instrument turns on in its default condition: 850/1300 nm Dual mode sending Wavelength ID.
Low Battery indicator5. - Lights up when a Low Battery condition exists; batteries require
replacement.
External Power indicator6. - Lights up, whether the unit is on or off, when the correct AC power
adapter is connected.
Power port7. (located on the top panel) - This is the interface for an AC power adapter.
OLS1-Dual LED Light Source
To Next Page
Loading...
Need help?
General
