10/27/15 SB05-4A Compactor manifold relief
2
SB05-4A
3. Refer to the chart below for the correct relief pressure setting of the compactor model
tested. To adjust the relief, use an 11/16” combination wrench to loosen the jam nut
and a 5/32” Allen wrench to adjust the relief screw.
C2C, D 2500
C3D 2500
C4C 2600
C6C 2600
C8C 2600
C10C 2600
C12C 2600
*Turn adjusting screw in to increase relief setting and turn out (counterclockwise) to reduce
relief setting (clockwise).
4. Lock jam nut when correct setting is achieved. Recheck pressure.
5. Reassemble unit.
To Next Page
Loading...