NTI FTG 600 - Page 33

FTG │Installation & Operation Manual
33
Figure 9-1(a) Gas Valve Assembly (FTG 600-1400)
DO NOT Adjust
Gas Valve
Manifold Pressure Test Port
(located on gas valve outlet
flange)
Throttle / Input Adjustment
Screw (use 3 mm hex wrench)
Line Pressure Test Port
(located on gas valve inlet
flange)
Venturi
Combustion Blower
Air Filter
Cap (remove to access Throttle
Adjustment Screw)
Low Gas Pres. Switch
(auto-reset)
High Gas Pres. Switch
(manual reset)
Front-Top Cover (must be removed
to access Gas Valve components)