Trinity │Installation and Operation Instructions Tft Series
Table 16-3 Hold and Lockout Codes
Safety opto bad in test state
Safety relay opto feedback incorrect
Safety relay feedback incorrect in run
Main relay feedback incorrect
Pilot relay feedback incorrect
Safety relay feedback incorrect
Main relay ON at safe start check
Pilot relay ON at safe start check
Safety relay ON at safe start check
Invalid Blocked condensate enable setting
Invalid J7-1 configuration, both LFS and Blocked condensate
Invalid J7-2 configuration, both HFS and Flap valve
Invalid BLOWER/HSI output setting
Invalid Delta T limit enable setting
Invalid Delta T limit response setting
Invalid DHW high limit enable setting
Invalid DHW high limit response setting
Invalid Flame sensor type setting
Invalid interrupted air switch enable setting
Invalid interrupted air switch start check enable setting
Invalid Igniter on during setting
Invalid Ignite failure delay setting
Invalid Ignite failure response setting
Invalid Ignite failure retries setting
Invalid Ignition source setting
Invalid Interlock open response setting
Invalid Interlock start check setting
Invalid LCI enable setting
Invalid light off rate setting
Invalid Light off rate proving setting
Invalid Main Flame Establishing Period time setting
Invalid MFEP flame failure response setting
Invalid NTC sensor type setting
Invalid Outlet high limit response setting
Invalid Pilot Flame Establishing Period setting
Invalid PII enable setting
Invalid pilot test hold setting
Invalid Pilot type setting
Invalid Post-purge time setting
Invalid Power up with lockout setting
Invalid Pre-ignition time setting
Invalid Pre-purge rate setting
Invalid Pre-purge time setting
To Next Page
Loading...
