NTI Trinity Tft285 - Page 76

Trinity │Installation and Operation Instructions Tft Series
76
Table 16-3 Hold and Lockout Codes
Code
Description
Note
264
Invalid preferred outlet high limit setting
Lockout
265
Invalid preferred lightoff rate setting
Lockout
266
Invalid preferred stack limit rate setting
Lockout
Table 16-4 Alert Codes
Code
Description
0
None (No alert)
1
Alert PCB was restored from factory defaults
2
Safety configuration parameters were restored from factory defaults
3
Configuration parameters were restored from factory defaults
4
Invalid Factory Invisibility PCB was detected
5
Invalid Factory Range PCB was detected
6
Invalid range PCB record has been dropped
7
EEPROM lockout history was initialized
8
Switched application annunciation data blocks
9
Switched application configuration data blocks
10
Configuration was restored from factory defaults
11
Backup configuration settings was restored from active configuration
12
Annunciation configuration was restored from factory defaults
13
Annunciation configuration was restored from backup
14
Safety group verification table was restored from factory defaults
15
Safety group verification table was updated
16
Invalid Parameter PCB was detected
17
Invalid Range PCB was detected
18
Alarm silence time exceeded maximum
19
Invalid safety group verification table was detected
20
Backdoor password could not be determined
21
Invalid safety group verification table was not accepted
22
CRC errors were found in application configuration data blocks
23
Backup Alert PCB was restored from active one
24
RESERVED
25
Lead Lag operation switch was turned OFF
26
Lead Lag operation switch was turned ON
27
Safety processor was reset
28
Application processor was reset
29
Burner switch was turned OFF
30
Burner switch was turned ON
31
Program Module (PM) was inserted into socket
32
Program Module (PM) was removed from socket
33
Alert PCB was configured
34
Parameter PCB was configured
35
Range PCB was configured
36
Program Module (PM) incompatible with product was inserted into socket
37
Program Module application parameter revision differs from application processor
38
Program Module safety parameter revision differs from safety processor
39
PCB incompatible with product contained in Program Module
40
Parameter PCB in Program Module is too large for product
41
Range PCB in Program Module was too large for product