Tft Series Installation and Operation Instructions │Trinity
CH control was suspended due to fault
CH header temperature was invalid
CH outlet temperature was invalid
CH steam pressure was invalid
Minimum water temperature parameter was greater than setpoint
Minimum water temperature parameter was greater than time of day setpoint
CH modulation rate source parameter was invalid
DHW demand source was invalid
DHW OFF hysteresis was invalid
DHW ON hysteresis was invalid
DHW hysteresis step time was invalid
DHW sensor type was invalid
Inlet sensor type was invalid for DHW
Outlet sensor type was invalid for DHW
DHW storage OFF hysteresis was invalid
DHW storage ON hysteresis was invalid
DHW modulation sensor type was invalid
DHW modulation sensor was not compatible for Auto mode
DHW control was suspended due to fault
DHW temperature was invalid
DHW inlet temperature was invalid
DHW outlet temperature was invalid
DHW high limit must be disabled for Auto mode
DHW sensor type was not compatible for Auto mode
DHW priority source setting was invalid
DHW priority method setting was invalid
CH S5 (J8-11) sensor was invalid
CH Inlet temperature was invalid
CH S10 (J10-7) sensor was invalid
Lead Lag CH setpoint source was invalid
Lead Lag P-gain was invalid
Lead Lag I-gain was invalid
Lead Lag D-gain was invalid
Lead Lag OFF hysteresis was invalid
Lead Lag ON hysteresis was invalid
Lead Lag slave enable was invalid
Lead Lag hysteresis step time was invalid
No Lead Lag Modbus port was assigned
Lead Lag base load common setting was invalid
Lead Lag DHW demand switch setting was invalid
Lead Lag Mix demand switch setting was invalid
Lead Lag modulation sensor setting was invalid
Lead Lag backup modulation sensor setting was invalid
Lead Lag slave mode setting was invalid
Lead Lag rate allocation setting was invalid
Lead selection setting was invalid
To Next Page
Loading...
