Tft Series Installation and Operation Instructions │Trinity
CH ODR time of day setpoint was invalid
CH ODR time of day set point exceeds normal set point
CH max outdoor set point was invalid
CH min outdoor setp oint was invalid
CH min water set point was invalid
CH outdoor temperature range was too small (minimum 12 C / 22 F)
CH water temperature range was too small (minimum 12 C / 22 F)
CH ODR min water temperature was invalid
DHW set point was invalid
DHW time of day set point was invalid
DHW storage setpoint was invalid
STAT may not be a DHW demand source when Remote Stat is enabled
No DHW anticondensation setpoint was configured
No CH anticondensation setpoint was configured
STAT may not be a CH demand source when Remote Stat is enabled
CH 4mA water temperature setting was invalid
CH 20mA water temperature setting was invalid
Steam 4mA water temperature setting was invalid
Steam 20mA water temperature setting was invalid
Abnormal Recycle: Pressure sensor fault
Abnormal Recycle: Safety relay drive test failed
Abnormal Recycle: Demand off during Pilot Flame Establishing Period
Abnormal Recycle: LCI off during Drive to Purge Rate
Abnormal Recycle: LCI off during Measured Purge Time
Abnormal Recycle: LCI off during Drive to Light off Rate
Abnormal Recycle: LCI off during Pre-Ignition test
Abnormal Recycle: LCI off during Pre-Ignition time
Abnormal Recycle: LCI off during Main Flame Establishing Period
Abnormal Recycle: LCI off during Ignition period
Abnormal Recycle: Demand off during Drive to Purge Rate
Abnormal Recycle: Demand off during Measured Purge Time
Abnormal Recycle: Demand off during Drive to Light off Rate
Abnormal Recycle: Demand off during Pre-Ignition test
Abnormal Recycle: Demand off during Pre-Ignition time
Abnormal Recycle: Flame was on during Safe Start check
Abnormal Recycle: Flame was on during Drive to Purge Rate
Abnormal Recycle: Flame was on during Measured Purge Time
Abnormal Recycle: Flame was on during Drive to Light off Rate
Abnormal Recycle: Flame was not on at end of Ignition period
Abnormal Recycle: Flame was lost during Main Flame Establishing Period
Abnormal Recycle: Flame was lost early in Run
Abnormal Recycle: Flame was lost during Run
Abnormal Recycle: Leakage test failed
Abnormal Recycle: Interrupted air flow switch was off during Drive to Purge Rate
Abnormal Recycle: Interrupted air flow switch was off during Measured Purge Time
Abnormal Recycle: Interrupted air flow switch was off during Drive to Light off Rate
Abnormal Recycle: Interrupted air flow switch was off during Pre-Ignition test
Abnormal Recycle: Interrupted air flow switch was off during Pre-Ignition time
To Next Page
Loading...
