NuAire GENIE - User Manual

1
27. 04. 21. Document Number 671182
Nuaire | Western Industrial Estate | Caerphilly | CF83 1NA | nuaire.co.uk
GENIE
Universal Surface Mounted Fans
Installation Manual
1.0 SAFETY INFORMATION
• The provision of the electrical supply and the connection of the unit to the electrical supply
must be carried out by a qualified electrician in accordance with latest edition of the wiring
regulations.
• Isolate from power supply before removing any covers. During installation / maintenance ensure
all covers are fitted before switching on the mains supply.
• All-pole disconnection from the mains as shown in the wiring diagram must be incorporated
within the fixed wiring and shall have a minimum contact separation of 3mm in accordance with
latest edition of the wiring regulations.
• 230V Genie units must be earthed.
• Ducting must be securely fixed to the spigot to prevent access to live parts. Duct runs
terminating close to the fan must be adequately protected by suitable guards.
• Precautions must be taken to avoid the back-flow of gases into the room from the open flue of
gas or other fuel-burning appliances.
• This appliance should not be used by children or persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge, unless they have been given supervision
or instruction concerning the safe use of the appliance by a person responsible for their safety.
Children shall not play with the appliance. Cleaning and user maintenance shall not be carried
out by children.
1.1 Hazard Symbols
GENERAL WARNING
Signifies a general warning regarding hazard specified by supplementary information.
ELECTRIC SHOCK
This unit must be completely electrically isolated before any panels are removed. Check
mains supply and control connections.
ROTATING PARTS
This unit contains fast moving rotational parts which may start automatically. It is the
sole responsibility of the installer to adequately guard these components.
REFER TO INSTRUCTION MANUAL
Read and understand the installation and maintenance manual before installing,
operating or maintaining this product.

Summary

Safety Information and Hazard Symbols

Hazard Symbols Explained

Explains general warning, electric shock, rotating parts, and instruction manual symbols with their meanings.

Personal Protective Equipment

Introduction to Genie Fans

Mechanical Installation Guide

Surface Mounting Procedures

Details requirements for mounting the unit on a solid surface, including ductwork preparation.

Semi-Recessed Ceiling Mounting

Window Mounting Instructions

Transformer Enclosure for 12 V Units

Electrical Installation and Information

Electrical Specifications and Power Consumption

Provides details on power consumption for 230V and 12V units, including transformer data.

Wiring and Control System Details

230 V Unit Wiring via Remote Switch

Describes wiring connections for 230V GENIE units controlled by a remote switch.

230 V Unit Wiring via Pull Cord or PIR

Outlines wiring for 230V GENIE units using a pull cord or PIR sensor.

12 V Unit Wiring via Pull Cord

Details wiring connections for 12V GENIE units operated by a pull cord.

12 V Unit Wiring via Remote Switch

Shows wiring diagrams for 12V GENIE units controlled via a remote switch.

Run-On Timer Adjustment

Explains how to adjust and set the run-on timer feature for the GENIE unit.

Humidity Set Point Adjustment

Describes how to adjust the humidity set point for the unit's humidistat function.

Maintenance and Care Procedures

Routine Maintenance Schedule

Details the recommended 6-month schedule for cleaning and checking the unit's filters.

Step-by-Step Cleaning Guide

Provides step-by-step instructions for cleaning the fan module, front cover, and filter.

Warranty Information

End-of-Life Recycling Guidelines

After Sales Support and Parts

Base Drill Pattern Diagram

NuAire GENIE Specifications

General

Brand	NuAire
Model	GENIE
Category	Fan
Language	English