To Next PageTo Next Page
Need help?Do you have a question about the NuAire NU-4850E and is the answer not in the manual?
General| Brand | NuAire |
|---|---|
| Model | NU-4850E |
| Category | Accessories |
| Language | English |
Details the 20-gallon water-jacket design and its benefits for temperature uniformity.
Explains the solid-state infrared CO2 analyzer and its measurement capabilities.
Describes the NICE microcomputer control system and its features.
Describes the RH control system and its operation for NU-4850/4950 models.
Explains the optional O2 display and control system for NU-4950 models.
Highlights additional features specific to the NU-4850 model.
Highlights additional features specific to the NU-4950 model.
Details the standard features of the NU-4750 model incubator.
Details electrical tests including leakage, dielectric voltage, and grounding.
Outlines functional tests performed on control systems and performance parameters.
Provides procedures for handling and claiming damaged shipments.
Covers electrical supply requirements and connection safety precautions.
Instructions for connecting CO2 and N2 gas supply tubing to the incubator.
Describes the operation of the control panel keypads and modes.
Explains humidity generation for NU-4750 and relative humidity control for NU-4850/4950.
Details the system's automatic fault detection and alarm notification process.
Details keypad operation for mode selection and parameter input.
Guide to setting chamber temperature, CO2, humidity, and O2 levels.
Lists and describes parameters available for output testing in diagnostic mode.
Step-by-step guide for calibrating the chamber temperature sensor.
Details calibration of the door heater duty cycle for condensation control.
Guides for zero/span calibration of the CO2 sensor using open or closed door methods.
Calibrating CO2 injection time for optimal recovery after door openings.
Overview of CO2 calibration techniques: control, sensor, and injection.
Describes the automatic zero calibration routine for the CO2 sensor.
Procedure for calibrating the CO2 control system based on external measurements.
Steps for calibrating the O2 sensor on NU-4950 models.
Guide to identifying and correcting error codes displayed by the incubator.
