2.9.1 Update software via FTP
This software update method preserves the current settings.
1. From the command prompt window, issue the ftp command. Enter:
ftp <IP address>
The SafeCom Controller prompts you for a username and a password. Both
are adm by default.
2. Put the SafeCom Controller into software update mode by downloading
the software file into the codes folder. Enter:
cd codes
put <software file>.b80
The command prompt window displays the text "Restarting ... Login again
to update the software".
3. Logout of the ftp session. Enter:
quit
4. Start a new ftp session and log in. Enter:
ftp <IP address>
The command prompt window displays the text "Logged in for software
update".
5. Set the binary transfer type and download (put) the software file. Enter:
binary
hash
put <software file>.b80
The software is updated. The SafeCom Controller automatically restarts
after a successful update and CRC check. Do not interfere with the
SafeCom Controller until it has restarted.
6. Logout of the ftp session. Enter:
quit
To Next Page
Loading...