NUCLEONIX SYSTEMS GA720 User Manual

I N S T R U C T I O N
M A N U A L
GAMMA AREA MONITOR
TYPE : GA720
NUCLEONIX SYSTEMS PRIVATE LIMITED
Plot No : 162 A & B, PHASE II, I.D.A.Cherlapally, Hyderabad - 500 051
Ph: 91-040-27263701/30918055, FAX : 27262146, e-mail : info@nucleonix.net
File Name : GA720_Man
Date : 02-04-2012

NUCLEONIX SYSTEMS GA720 Specifications

General

Brand	NUCLEONIX SYSTEMS
Model	GA720
Category	Measuring Instruments
Language	English

Summary

CHAPTER-I INTRODUCTION

Overview and Purpose

Introduces the Gamma Area Monitor GA720 and its general use.

CHAPTER - II FRONT PANEL & SIDE PANEL CONTROLS

2.1 Front Panel Controls

Details on Normal/Active Lamps, Dose Rate Display, Status Display.

2.2 Side Panel Controls

Details on Mains connector, ON switch, Audio Alarm.

CHAPTER - III SPECIFICATIONS

Device Specifications

Comprehensive list of technical specifications for the GA720 monitor.

CHAPTER - IV INSTALLATION

Installation Procedure

Instructions for setting up the Gamma Area Monitor for operation.

CHAPTER - V OPERATING INSTRUCTIONS

Operating Procedures and Configuration

Detailed guide on operating, configuring, and using the GA720 monitor.

CHAPTER - VI SIDE PANEL CONNECTOR DETAILS

Connector Pinouts and Details

Information on the 3-pin, 17-pin, and 6-pin MS connector pinouts.

CHAPTER - VII CALIBRATION

Calibration Procedure and Standards

Details on the calibration process, sources, and accuracy.

CHAPTER - VIII AVAILING OF MAINTENANCE/ CALIBRATION SERVICES AND WARRANTY CLAUSE (with in India)

8.1 General Warranty and Service Terms

General terms and conditions for warranty and service.

8.2 Equipment Repairs Policy (India)

Procedure for availing repair services within India during warranty.

8.3 Equipment Repairs Policy (Exports)

Policy for equipment repairs and servicing for overseas customers.

8.4 Calibration Services (Indian Customers)

Steps for Indian customers to avail calibration services.

8.5 Calibration Services (Foreign Customers)

Guidance for foreign customers on calibration services.

8.5 Annual Maintenance Contract (AMC)

Details and advantages of Annual Maintenance Contracts.

CHAPTER - IX BLOCK DIAGRAM DESCRIPTION

Block Diagram Analysis

Description of the detector probe and main PCB circuits.

CHAPTER - X FACTORY ACCEPTANCE TEST / QA REPORT / CALIBRATION DATA

Factory Acceptance Test Procedures

Overview of Factory Acceptance Test, QA Report, and Calibration Data.