EasyManua.ls Logo

Num'axes PIE 1010 - Advanced Features and Communication; SMS commands

Num'axes PIE 1010
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Piège photographique / Trail camera # PIE 1010 – Guide d’utilisation / User’s guide – indice A
35/40
8. SMS commands
You have the option to control the camera remotely via text messages (SMS commands). You
can switch from photo mode to video mode and vice versa, take a picture and receive it, change
the video or photo resolution, etc.
To send a command to the device, you have to insert a code in a text message and send it to
the phone number of the SIM card inserted in the camera.
IMPORTANT
The MMS or SMTP status must be set to “ON” (800x600, VGA or SMS) in the MMS/SMTP
setup for the SMS function to work. It will not work if the MMS or SMTP status is set to
OFF.
Some towers do not support all commands.
You must have a phone number entered in, in order to send commands to the phone. If
you only have an e-mail in the MMS/SMTP setup menu, you cannot use the SMS option.
The phone number in position 1 in the phone number list will be used as the “commander
phone number” and only it has the rights to edit the SMS command orders to control the
camera.
Both MMS and SMTP allow control of the camera remotely via text messages.
The table below lists the actions or setting changes you can request and the various text
messages which you have to send to your camera:
Requested action or setting change SMS text commands
Switch to camera mode *CM*
Switch to video mode *VM*
Set photo resolution at 5 MP *C*1*
Set photo resolution at 8 MP *C*2*
Set photo resolution at 12 MP *C*3*
Set video resolution at VGA *V*1*
Set video resolution at 720 P (HD) *V*2*
Set video resolution at 1080 P (Full HD) *V*3*
Set PIR interval at 1 minute *P*1M*
Set PIR interval at 10 minutes *P*10M*
Set PIR interval at 15 minutes *P*15M*
Set PIR interval at 30 minutes *P*30M*
Set PIR interval at 60 minutes *P*60M*
Set PIR sensitivity at low *S*1*
Set PIR sensitivity at medium *S*2*
Set PIR sensitivity at high *S*3*
Set IR LED at medium *L*1*
Set IR LED at high *L*2*
Capture a picture, video or photo + video (in ON or TEST mode) *GH*

Related product manuals