5 - 28 en-938821/2
No programme end character (See Programming manual)
When the loading procedure has been completed, the CNC waits for the programme end character.
There are two possibilities:
Cancel the loading procedure. ☞
Edit the programme to be loaded and restart the loading procedure.
or
Send a programme end character (if allowed by the peripheral).
Exit from the procedure
Stop the loading procedure. ☞
The "INCYC" indicator disappears and the "FILE LOADING" menu is displayed.
The peripheral stops sending data.
The part of the programme which has already been read is not stored.
5.4.1.2 Selection of Active Programme
Before a programme can be executed, it must first be selected as the active programme.
Requirements
"FILE LOADING" menu displayed (See 5.4.1).
Actions
Select "ACTIVE PROGRAMME SELECTION". ☞
#
3
The cursor moves to the following line:
3 ACTIVE PROGRAMME SELECTION
Confirm active programme selection. ☞
The "INCYC" indicator is displayed in the status window (see 3.1.3) and the following message is displayed in the
dialogue line:
(%..) ❚
Enter "% [Programme No.]". ☞
The programme selected is displayed and becomes the active progamme.
The "INCYC" and "FILE LOADING" indicators disappear.
Incidents
If no programme exists with this number or the programme number is incorrectly written, the cursor moves to the "%"
when an attempt is made to confirm this number.
Select another programme number and confirm it.
To Next Page
Loading...
