Need help?Do you have a question about the NUM 1040 W and is the answer not in the manual?
General| Type | CNC Controller |
|---|---|
| Manufacturer | NUM |
| Model | 1040W |
| Power Supply | 24 VDC |
| Interpolation | Linear, Circular, Helical |
| Control System | NUM Flexium |
| Communication Interface | Ethernet, USB |
| Programming Language | ISO |
| PLC | Integrated |
Details different NUM panels (QWERTY, 50-key, Compact) and their components.
Details keyboard keys, softkeys, and indicators on the operator panel.
Explains displaying programmes graphically, including parameters, traces, simulation, and 3D views.
Covers operator-controlled jog operations and axis homing procedures.
Details part setting, tool setting, and loading/entering tool offsets.
Explains loading programmes, debugging, and executing them in various modes.
Covers unplanned and programmed interventions during programme execution.
Provides troubleshooting steps for when the "FDHLD" indicator is displayed.
Guides on troubleshooting when manual controls do not generate movement.
Explains troubleshooting steps for when no movement occurs in automatic mode.
Details troubleshooting steps when the cycle does not start and "INCYC" indicator is absent.
Explains troubleshooting when movements stop at block end, with or without "INCYC" indicator.
Describes fault indicator (NC??) and messages displayed by the system.
Provides a procedure for restarting machining after a power failure.
Describes messages displayed at initialization indicating potential hardware faults.
Covers backing up and restoring machine data including software options and parameters.
Covers managing protected memory areas for programmes, including password protection.
To Next Page
