en-938821/2 7 - 7
System Faults
7
7.5 Sampling Period Too Small
Message displayed at initialisation
SAMPLING PERIOD TOO SMALL !
IT MUST BE, AT LEAST, EQUAL TO
XXXX MICROSECONDS
FOR THE NUMBER OF AXIS/SPINDLES
SPECIFIED IN MACHINE SETUP DATA
DO YOU WANT TO CONTINUE ? (Y/N)
Comment
The sampling period set by parameter P50 (See Parameter manual) is too short to deal with the number of axes and
spindles to be measured.
Actions
Check the minimum sampling period (T) recommended by the message.
Acknowledge the message. ☞
Y
The system is available, but the axes and spindles are ignored.
The system fault indicator «CLKOV» is displayed in the status window (See 3.1.3).
Enter the sampling period value (T) in parameter P50 (See Parameter manual).
Reset the system to take the new value into account.
If the problem persists:
Progressively increase the value of parameter P50 until operation is correct.
REMARK Setting a P50 parameter value higher than necessary reduces the system
performance; it is therefore advised not to increase this value too much.
To Next Page
Loading...
Need help?
General
