Need help?Do you have a question about the NUM 1040 M and is the answer not in the manual?
General| Type | CNC Controller |
|---|---|
| Manufacturer | NUM |
| Model | 1040 M |
| Interpolation | Linear, Circular, Helical |
| PLC | Integrated |
| Axis Control | Digital |
| Communication | Ethernet, RS-232 |
| Programming Language | ISO G-code |
| Display | LCD |
Covers axis homing and jog operations before programmed movement.
Details part setting, origin shifts, and tool setting procedures.
Procedures for entering and executing instructions manually.
Covers loading, selecting, and executing part programs automatically.
Operator actions during machining incidents or programmed stops.
Methods for creating part programs using interactive tools.
Troubleshooting steps when the "FDHLD" indicator is shown.
Diagnosing issues with manual control inputs.
Diagnosing issues when no movement occurs in automatic mode.
Troubleshooting why a cycle fails to start.
Problems related to program block execution sequence.
Procedure for restarting after a power interruption.
Identifies hardware-related initialization errors.
Addresses issues with insufficient sampling periods for axes/spindles.
Fault when a declared axis is not present or configured.
Error where a sensor is declared multiple times on a QVN card.
Sensor address outside authorised limits for QVN.
Sensor detected on the wrong card type.
Speed sensor connected to QVN but not declared.
Speed sensor declared multiple times.
Sensor declared for multiple axes.
Sensor not found or misdeclared.
Address conflict for multiple axis drive sensors.
Mismatch between drive and QVN axis lists.
QVN axes are missing from the servo-controlled list.
Missing measured-only axes in QVN list.
Procedures for backing up and restoring machine data.
To Next Page
