Need help?Do you have a question about the NUM 1060 W and is the answer not in the manual?
Details the procedure for switching on the machine and restarting after an emergency stop.
Explains how to display tool dimensions, cutter tip radius, and tool wear offsets.
Covers displaying programmes in graphic mode, including parameters and contour traces.
Covers initial operations like axis homing and operator-controlled jog.
Details part setting, tool setting, and entering shifts/scaling factors.
Covers loading, creating, debugging, and executing programmes automatically.
Describes troubleshooting steps when the "FDHLD" indicator is displayed.
Provides troubleshooting steps for when manual controls generate no movement.
Offers troubleshooting for cases where no movement occurs in automatic mode.
Details troubleshooting steps when the cycle does not start.
Explains troubleshooting for 'No Block Sequencing' with or without 'INCYC' indicator.
Provides a procedure to restart machining after a power failure.
Describes messages displayed at initialization related to hardware faults.
Explains messages related to missing declared axes and parameter P2.
Explains errors when a sensor is declared multiple times on a QVN card.
Discusses errors related to QVN sensor addresses outside authorised values.
Covers errors where a sensor is declared on QVN but detected on an axis card.
Addresses errors for undeclared speed sensors connected to the QVN card.
Explains errors when a speed sensor is declared multiple times.
Details errors when speed/position sensors are declared on multiple axes.
Covers errors where a position sensor is not found on an axis card or declared to QVN.
Covers hardware maintenance like battery replacement and adding memory modules.
Covers backing up and restoring machine data including software options and parameters.
Lists miscellaneous and machine errors with their meanings and error numbers.
Lists errors related to travel overruns on axes X, Y, Z, U, V, W, A, B, C.
Details the procedure for switching on the machine and restarting after an emergency stop.
Explains how to display tool dimensions, cutter tip radius, and tool wear offsets.
Covers displaying programmes in graphic mode, including parameters and contour traces.
Covers initial operations like axis homing and operator-controlled jog.
Details part setting, tool setting, and entering shifts/scaling factors.
Covers loading, creating, debugging, and executing programmes automatically.
Describes troubleshooting steps when the "FDHLD" indicator is displayed.
Provides troubleshooting steps for when manual controls generate no movement.
Offers troubleshooting for cases where no movement occurs in automatic mode.
Details troubleshooting steps when the cycle does not start.
Explains troubleshooting for 'No Block Sequencing' with or without 'INCYC' indicator.
Provides a procedure to restart machining after a power failure.
Describes messages displayed at initialization related to hardware faults.
Explains messages related to missing declared axes and parameter P2.
Explains errors when a sensor is declared multiple times on a QVN card.
Discusses errors related to QVN sensor addresses outside authorised values.
Covers errors where a sensor is declared on QVN but detected on an axis card.
Addresses errors for undeclared speed sensors connected to the QVN card.
Explains errors when a speed sensor is declared multiple times.
Details errors when speed/position sensors are declared on multiple axes.
Covers errors where a position sensor is not found on an axis card or declared to QVN.
Covers hardware maintenance like battery replacement and adding memory modules.
Covers backing up and restoring machine data including software options and parameters.
Lists miscellaneous and machine errors with their meanings and error numbers.
Lists errors related to travel overruns on axes X, Y, Z, U, V, W, A, B, C.
General| Brand | NUM |
|---|---|
| Model | 1060 W |
| Category | Controller |
| Language | English |
To Next Page
