Display System Utilization
en-938821/2 4 - 1
4
4 Display System Utilization
4.1 Inch/Metric Unit Conventions 4 - 3
4.2 Display of Tool Position 4 - 3
4.3 Display of Shifts 4 - 5
4.4 Display of Tool Data and Tool Corrections 4 - 6
4.5 Display of Programmes 4 - 8
4.5.1 Access to the List of Programmes 4 - 9
4.5.2 Access to the Listing of a Programme 4 - 10
4.5.3 Access to a Programme Listing at a Given
Sequence 4 - 11
4.6 Display of a Programme in Graphic Mode 4 - 12
4.6.1 Selection of Graphic Display Parameters
and Part Contour Trace 4 - 13
4.6.1.1 Selection of Graphic Display Parameters 4 - 13
4.6.1.2 Part Contour Trace 4 - 15
4.6.1.3 Scaling of Display Planes 4 - 17
4.6.2 Machining Simulation 4 - 18
4.6.3 3D Display 4 - 21
4.6.4 Trace during Cutting 4 - 26
4.6.5 Selection of Graphic Display Parameters
and Part Contour Trace in Mixed Machine
Mode (MX) 4 - 29
4.6.5.1 Selection of Graphic Display Parameters 4 - 29
4.6.5.2 Part Contour Traces 4 - 31
4.7 Display of Active Data 4 - 33
4.8 Display of Programme-Being Executed 4 - 35
4.9 Display of Programme Variables and Equivalent Address Table 4 - 37
4.9.1 Display of Programme Variables 4 - 37
4.9.2 Display of Equivalent Address Table 4 - 38
4.10 Display of Inputs/Outputs 4 - 39
4.10.1 Display of Operator Messages 4 - 40
4.10.2 Display of External Parameters 4 - 42
4.10.3 Display of PLC Memory Data 4 - 44
4.10.4 Display of PLC User Screen 4 - 46
4.10.5 Display of QVN Information 4 - 46
4.10.6 Display of Ladder Animation 4 - 46
4.10.7 Display of Wire Tap 4 - 46
4.11 Access to Maintenance Functions 4 - 47
To Next Page
Loading...
Need help?
General
