NUM 1040 W User Manual

en-938821/2 7 - 13
System Faults
7
7.14 Undeclared Speed Sensor Connected to the QVN Card
Message displayed at initialisation
ERROR: UNDECLARED SPEED SENSOR CONNECTED
TO THE QVN CARD
CONTINUE (Y/N)?
Comment
A speed sensor address is declared in parameter P71 but the sensor is not declared as connected in parameter P70
(See Parameter Manual).
Actions
Acknowledge the message. ☞
Y
The system is available, but the machining modes are inhibited and power cannot be applied to the system.
The "PRSOV" system fault indicator is displayed in the status window (See 3.1.3).
Declare the sensor as connected in parameter P70 (See Parameter Manual).
Reset the system to take the new parameter into account.
7.15 Speed Sensor Declared Several Times
Message displayed at initialisation
ERROR: SPEED SENSOR DECLARED
SEVERAL TIMES
CONTINUE (Y/N)?
Comment
A speed sensor is declared several times in parameter P71 (See Parameter Manual).
Actions
Acknowledge the message. ☞
Y
The system is available, but the machining modes are inhibited and power cannot be applied to the system.
The "PRSOV" system fault indicator is displayed in the status window (See 3.1.3).
Enter correct sensor addresses in parameter P71 (See Parameter Manual).
Reset the system to take the new parameter into account.

NUM 1040 W Specifications

General

Brand	NUM
Model	1040 W
Category	Controller
Language	English